
Not all defects in fabric show before cutting. Inspecting rolls protects you from sewing defects into whole garments.
A common system gives each defect points by its length: one point for a defect up to 3 inches, two from 3 to 6, three from 6 to 9, and four above 9. Points are then expressed per 100 square yards with the formula: total points × 3600 ÷ (roll length in yards × width in inches).
A roll 100 yards long and 60 inches wide has three defects: 2 inches (1 point), 5 inches (2 points) and 10 inches (4 points). Total 7 points. Result = 7 × 3600 ÷ (100 × 60) = 4.2 points per 100 square yards. Both sides agree an acceptance limit; limits around 40 points are often used, but agree what suits you.
Open the four point inspection template and try the numbers from the lesson. Then write the acceptance limit you will ask the supplier for.